4g61t.org

Specializing in the 3g CSM
It is currently Mon Nov 03, 2025 4:46 am

» »

All times are UTC-05:00



Post new topic  Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
Frankencolt
 Post subject: 1.7L 4g61t
PostPosted: Fri May 04, 2012 8:00 pm 
Offline
Newbie

Joined: Wed Oct 11, 2006 3:48 pm
Posts: 37
Location: Lewisporte, NL, Canada
I have an old 4g61t block lying around that I've been trying to put back together, but I don't have the stock pistons. I was wondering if these pistons would work? (with boring of course) http://www.built4g63.com/Wossner-8-1-2. ... n-Kit.html
I figure it should work with the stock length rods, since the stroke difference between the 63 and 64 is 12 mm and between the 61 and 63 is 13mm... Any thoughts?
Top
   
Reply with quote  
ColtiXim
 Post subject: Re: 1.7L 4g61t
PostPosted: Sat May 05, 2012 1:39 am 
Offline
CSM Junkie
User avatar

Joined: Sun Mar 09, 2008 5:43 am
Posts: 580
Location: FRANCE
Good infos here:

http://www.4g61t.org/forum/viewtopic.ph ... g63+piston
http://www.4g61t.org/forum/viewtopic.ph ... g63+piston
http://www.4g61t.org/forum/viewtopic.ph ... g63+piston
Top
   
Reply with quote  
Frankencolt
 Post subject: Re: 1.7L 4g61t
PostPosted: Sat May 05, 2012 2:27 am 
Offline
Newbie

Joined: Wed Oct 11, 2006 3:48 pm
Posts: 37
Location: Lewisporte, NL, Canada
So, really I could use stock 63 pistons, I'd just have to shave .5mm off the top?
Top
   
Reply with quote  
Display posts from previous:  Sort by  
Post new topic  Reply to topic  Page 1 of 1
  [ 3 posts ] 

» »

All times are UTC-05:00

Who is online

Users browsing this forum: No registered users and 7 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited