4g61t.org

OK lets pretend for a minute that my car is not a 1.5 powered, primered turd . How do you think these lights look? I did it myself with the cheap $10 ebay decal. Took me about 20 minutes to do one with a hairdryer and and some windex. Getting out all of the bubbles wasn't too bad.

I was also thinking about just doing half of the light like the JDM ones but I wanted to be sure before cutting this and messing it up because they only send enough to do each light so half of it is already gone.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual

sorry doesnt look good to me and im guessing that would decrease light output also at night? these films would look better for foglights though

_________________
My feedback thread:

http://www.4g61t.org/phpBB2/viewtopic.php?t=18146

Honestly thats why I ordered it. I was going to attempt to make one of those grills with the two fog lights in it and use the tint on those. I will eventually when I have time. I'm sure this would decrease some of the light output for sure. How much, I don't know yet.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual

I think it would look better if it were done JDM style with only half the headlight being yellow, but even that is faking the funk because the amber is inside the housing on a JDM light. No way to win there, you should just quit being such a ricer.

_________________
91 GSX - 511fwhp and 352 lb/ft 25psi 110 octane, 7.68 @ 95.9mph 1/8th 21psi 91 octane, 11.93 @ 112.9mph, 117.7mph best trap speed, 20psi 91 octane
98 Volvo S70 T5 - DD

http://www.facebook.com/captaintonus

Haha, I'll try. I think I'll keep what I have left to put on the fog lights. Another project for another day.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual

Not a huge fan of yellow headlights, makes them look dingy imo.

_________________
Had a:
1991 Eagle Summit ES Hatchback - 4g15 12v 5spd
1991 Dodge Colt -4g15 12v 4spd
Have a:
1978 Oldsmobile Cutlass - 468BBO TH350
Round 3:
1990 Dodge Colt-4G63T 5spd

Looks like I was the only one who liked it, if your car was all jdm hooked up, you could make it look like one of the cup cars. but with the state your car is in now, I would switch back to clear to not look ricerish.

_________________
4g61t.org
4g61t.com

I ended up peeling it back off today. I did drive it the other night though and believe it or not I could actually see better with the yellow tint, it was weird.

Now I'm thinking about pulling the lights apart and tinting the inside. Not the glass, the reflective part around the bulb. This stuff was a PITA to remove so it should stay on well. I may pick up a spare light from the junkyard to toy around with.

I agree Dave, would look a lot nicer if my car was finished or had a full JDM bodykit on it. Then maybe I could pull it off.

It was funny to drive around on a primered colt with one yellow light for a few days though.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual