4g61t.org

Looking to purchase: for my AWD 1989 Mitsu mirage:
shortened and balanced preferably aluminum drive shaft for a 4 bolt rear and 5 speed tranny (if that makes a difference)
10 Gallon fuel cell
4g63 engine mounts (either weld or bolt in)

The turbo mirage:
Front and rear bumpers
side skirts
As well as a hood


6 bolt 4g63t
6 bolt 4g63t engine harness (as unhacked as possible)

either post then pm or post then text (774-294-1573)

im located in MA

Turbo C53A and GT trims got a front bumper lip, and lower rocker panel side skirts. The front bumper and rear bumper are otherwise the same. Also, turbo and GT trims got the tailgate/roof spoiler.
There are locations on the inside of the front bumper to drill holes for attaching the lip.
Base bumpers are the same, they just weren't painted body color with red pin striping in the shipping cart "anti-ding" portions on the panels, bumper. If your car is a base model, it won't have the side trims that attach in the divot areas. Nor the holes to mount them.

I have a turbo model so i need the bumper with front lip and side skirts.

You can't just buy a shortened driveshaft. No one puts the rear end in the exact same spot, you'll need to measure and have the shaft shortened when you get to it.