4g61t.org http://4g61t.org/forum/ |
|
92 Talon AWD parts car. http://4g61t.org/forum/viewtopic.php?f=66&t=41336 |
Page 1 of 1 |
Author: | Dadstrong13 [ Wed Aug 21, 2019 10:02 am ] |
Post subject: | 92 Talon AWD parts car. |
This is a full car, last started it a few months ago. This will be almost everything you need to do an AWD swap into a CSM. Car is titled but unfortunately it’s a weird scenario where I didn’t know a rule that pertained to out of state titling. So I’d rather sell the car and all the other parts I have purchased to get it running. At this point I’m just over it and tired of it taking up space. 135,xxx miles. Tan/black leather in pretty good shape, typical 1g dash peel in a few places. Power steering has been looped to make room for manifold and wastegate (still have the pump). Still has all a/c parts, cruise control and heater core attached. Body is good, no rust, but the paint is oxidized and this is a non-sunroof car. 6 bolt motor (timing belt, tensioner, etc done about 2500 miles before it was purchased) 4 bolt rear end Manual trans Holset HY35 Turbo with stainless lines FMIC with full piping FIC 1440cc injectors* Walbro 255 Fuel Pump NGK plugs and wires Tubular Manifold Turbonetics External WG and BOV Slim fans x2* AEM Wideband* Autometer boost and A/F Autometer mech oil press* EPROM ECU with Ostrich 2.0 3" exhaust (ricer muffler) Lancer weighted shift knob Greddy Turbo Timer Kenwood CD player Clear corners Car does not run currently and will need trailored off. * denotes not on car and still new and unused. $2500 takes all of it. |
Author: | Dadstrong13 [ Wed Aug 21, 2019 1:32 pm ] |
Post subject: | Re: 92 Talon AWD parts car. |
Has T3 5-bolt exhaust side and will need a downpipe fabbed to connect to the 3” piping. |
Page 1 of 1 | All times are UTC-05:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |