| 4g61t.org http://4g61t.org/forum/ |
|
| holset hx52 http://4g61t.org/forum/viewtopic.php?f=66&t=39817 |
Page 1 of 1 |
| Author: | biglady112 [ Sun Jan 18, 2015 12:52 am ] |
| Post subject: | holset hx52 |
I am going to try and get as close to 1100hp as I can on my new setup and this turbo is just not going to get me there. This thing has been very faithful and delivered a tremendous amount of power consistently for a very long time. It has absolutely no shaft play in either direction. The turbine housing has had the v-band flange turned down so you can center the ring correctly for a 4" exhaust/downpipe. The inlet flange has been modified to bolt up to a regular T4 footprint without issue. I have fed this thing with a -4 bolt on fitting with a .065" restrictor from the oil filter housing and have never had issues. I have used a -10 oil return without issue as well it currently has the 16cm exhaust housing. I will send the turbo with a stock compressor housing as the current one has a snorkel welded to it for a -10 sealed catch can setup and a 90* elbow I was using in a RWD configuration. This thing made 800hp and 556tq@44psi through an automatic transmission. I will send it with cast hx52 71mm pro wheel that a friend bought and never used. $475 shipped with PayPal fees Pictures available if you ask. Steven 720-483-9375 |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|