4g61t.org

picked up a new project it is an 89 colt gt picked her up for $200 bucks with the engine trans and everything the engine needs a head so i plan on going to pick up a 1.8 head from the junkyard this weekend.







so far i have the head off and had the rear brake rotors turned and new rear pads now looking for new parking brake cables

_________________
89 plymouth colt gt work in progress

Can you take a pic of the rear exhaust/muffler setup? I need to put an exhaust on mine and wanted to do a dual exhaust exit like in your picture. I haven't planned it out yet though so I'm not sure if I'll do a single sideways muffler like a Dodge Neon or two small mufflers. Thanks.

_________________
'89 Colt GT w/bigger than stock turbo
'91 Talon AWD w/bigger than stock turbo
'05 Dodge diesel w/bigger than stock turbo

Nice! Make sure you add this to the VIN registry if you haven't done so already.

http://www.4g61t.org/forum/viewtopic.php?f=3&t=19530

_________________
91 GSX - 511fwhp and 352 lb/ft 25psi 110 octane, 7.68 @ 95.9mph 1/8th 21psi 91 octane, 11.93 @ 112.9mph, 117.7mph best trap speed, 20psi 91 octane
98 Volvo S70 T5 - DD

http://www.facebook.com/captaintonus

Nice! It looks really clean!

_________________
92 Colt GL 4g63t + AWD swap
00 Mirage LS

Good Find, Id like to see that exhaust too.

_________________
87 Starion, PROJECT. With the CATAPLT COLT engine, Thanks Craig, (GSX)
92 Eclipse GSX (Dead)
89 Colt GT (AWD Swap) H1C
88 Cummins Suburban
69 Cutlass convertible
78 Arrow G54B Swap, Celeste makeover. (MOD 2016 Veteran)

Can't wait to see it running. I say keep the paint fade, etc for the sleeper look. Good find!

Yummy GT seats! Not that bad.

the exhaust is just straight piped there is no muffler i am going to change it up if you still want pics i can get them. i am debating keeping the 61 or putting a 63 in it not sure yet

_________________
89 plymouth colt gt work in progress

well have not updated this have not had a lot of time with it. i have been building a 4g63 for the colt but ran into a minor drag on it. i was doing the 1g rods on 2g pistons took the rods to a local machine shop and the ruined the rods so now i am out a set of rods and the 100 i paid them. will post more pics soon

_________________
89 plymouth colt gt work in progress

I think I still have a set of 1g rods if you need them. They're already packed in a flat rate box ready to go, but they still have 1g pistons on them.