| 4g61t.org http://4g61t.org/forum/ |
|
| Does anybody have specs for 4g61T and the 4g63T http://4g61t.org/forum/viewtopic.php?f=6&t=8630 |
Page 1 of 1 |
| Author: | coltgtman [ Sat Apr 24, 2004 9:43 pm ] |
| Post subject: | Does anybody have specs for 4g61T and the 4g63T |
I just want to know the differences in them. Bore x stroke etc etc |
|
| Author: | mrcyborg [ Sun Apr 25, 2004 7:48 pm ] |
| Post subject: | |
sorry i dotn have an exact number for you but the stroke is about 10mm les and the bore is about 3mm from memory. |
|
| Author: | coltgtman [ Sun Apr 25, 2004 7:54 pm ] |
| Post subject: | I was told |
I was told that they are the same but for bore size is that true? That the rods and crank and all that stuff is the same. |
|
| Author: | Berserko [ Sun Apr 25, 2004 8:07 pm ] |
| Post subject: | |
The rods are the same the crank is different... |
|
| Author: | mrcyborg [ Sun Apr 25, 2004 8:18 pm ] |
| Post subject: | |
no they definatly have a shorter stroke. im sure is 10mm but might be a little either side. they have a different crank but they may have the same rod im not sure, they can do that using a different crank and different pistons im told. the stroke is the reason that the 1600 revs so hard. |
|
| Author: | mysteryman [ Sun Apr 25, 2004 10:00 pm ] |
| Post subject: | |
http://www.4g61t.com/forum/viewtopic.php?t=99&por=1%22 Liink to 4G61T specifications 4G61T 81MM bore 75.5MM stroke 4G63T 85MM bore 88MM stroke 1.6DOHC revs fast for three reasons: 1)short stroke 2)small size bore 3)no balance shafts Yes the two motors share the same connecting rod. |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|