| 4g61t.org http://4g61t.org/forum/ |
|
| 4g63(T) http://4g61t.org/forum/viewtopic.php?f=6&t=6206 |
Page 1 of 1 |
| Author: | sutiban [ Tue Nov 18, 2003 7:15 pm ] |
| Post subject: | 4g63(T) |
There is a 4g63T engine at a junk yard ~ 5 minutes from my Apt. I talked to the owner and he said he would let it go for $250. Here's the problem, no mani/turbo, unknown miles, unknown condition. Is it worth the $250, it probably needs a rebuild, if I got it I would rebuild it just cause of the unknown condition of the motor. Buy it or skip it? like my runon sentence? 
|
|
| Author: | jay [ Tue Nov 18, 2003 7:23 pm ] |
| Post subject: | |
If you got the time and tools to pull it, go for it. 50% chance its good. Just use your jugement while pulling it out. ie. cracks, holes, broken pieces and rat's nests. |
|
| Author: | miserymane [ Tue Nov 18, 2003 7:32 pm ] |
| Post subject: | |
is it for the motor and tranny or just the bottom and top end of the motor? |
|
| Author: | miragetec [ Tue Nov 18, 2003 7:34 pm ] |
| Post subject: | |
Just for reference, we sell good rebuildable long blocks for $450 |
|
| Author: | sutiban [ Tue Nov 18, 2003 8:33 pm ] |
| Post subject: | |
top and bottom, nothing else |
|
| Author: | miserymane [ Tue Nov 18, 2003 8:45 pm ] |
| Post subject: | |
thats not a bad price, if nothing else you could sell the head for like $150 if you wanted some of your money back if the block is garbage. I bought a junkyard motor before and the crank was worn pretty bad so i'm not using the bottom end, but i got the head, tranny, wiring harness, turbo, etc out of the deal. i'd say check out the motor for internal damage, if it's good then it's not a bad deal for $250 |
|
| Author: | miragetec [ Wed Nov 19, 2003 11:13 am ] |
| Post subject: | |
yep, that is for a perfect crank, no cylinder wear and a good head that needs surfacing, it is a engine that has either been bad ie. less that 130psi compression, excessive blow by, or slightly bent valves. we wouldent sell an engine with a valve stuck in the head. you would get the complete head,block, timing components, oil pan and front engine mount. |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|