Check out how miragetec did his on his AWD project. That one is a nice fit.
| 4g61t.org http://4g61t.org/forum/ |
|
| need help with FMIC install http://4g61t.org/forum/viewtopic.php?f=6&t=6157 |
Page 1 of 1 |
| Author: | 91_LaserRS [ Fri Nov 14, 2003 11:17 pm ] |
| Post subject: | need help with FMIC install |
anyone care to offer some hints to install a Starion FMIC into a colt. i looked at underdog web page. but didnt help me. i have already turned the one outlet pipe to face the same direction. cut the bumper support and front bumper just not sure how to route the piping it seems both pipes stop where the headlamp begins. thx for any help that you are able to provide |
|
| Author: | 91_LaserRS [ Sat Nov 15, 2003 7:57 am ] |
| Post subject: | |
bump sorry |
|
| Author: | Ricehunter [ Sat Nov 15, 2003 12:16 pm ] |
| Post subject: | |
Here's a link for an install on a 90 DSM it might help. http://www.vfaq.com/mods/StarionIC.html |
|
| Author: | cyborg [ Mon Nov 17, 2003 9:14 am ] |
| Post subject: | |
I removed my windshield washer bottle and ran the pipes between the radiator and body , some trimming was req'd . I have a small size battery in the stock location w/out the stock tray so I'm not sure if that would be in the way . If you mount the intercooler in the center of the lower bumper opening it should give you enough room to not hit the headlight . I hope this helps , sorry I don't have any good pictures either . |
|
| Author: | datster_2000 [ Mon Nov 17, 2003 10:50 am ] |
| Post subject: | |
Check out how miragetec did his on his AWD project. That one is a nice fit.
|
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|