| 4g61t.org http://4g61t.org/forum/ |
|
| Bolt patterns on 4g63 exhaust manifold http://4g61t.org/forum/viewtopic.php?f=6&t=4975 |
Page 1 of 1 |
| Author: | coltturbouk [ Fri Aug 15, 2003 6:34 pm ] |
| Post subject: | Bolt patterns on 4g63 exhaust manifold |
Anyone got a picture of the exhaust manifold from a Starion turbo? My engine's cracked (4g32) and I was going to get a 4g63 to replace it - they guy wants over the odds for it (just the bare block and head only, nothing else with it) but I reckon I can talk him down and get him to trhow in the exhaust manifold. IF it has a bolt bolt pattern that will fit a Garrett T3 then all I have left to buy is the Engine Management System. |
|
| Author: | coltturbouk [ Tue Aug 19, 2003 3:57 am ] |
| Post subject: | |
Can anyone help with this? I'm considering going 400 miles to get a complete 4G32 (1.6 turbo) engine with all the running gear - but I could spend the same on an immaculate 4g63 (2.0l 8V turbo) and the exhaust manifold locally. Then i just need other bits to get the car running properly again. I need to make my decision which I'm going for before Friday - because at the moment, transport to the other end of the country is a bit of a problem! Also related: What inlet manifolds can I put on the Starion engine? Does the galant MPi match up? Will a cyclone inlet manifold match up? If I'm going for the 2 litre, I'm going for an MPi manifold too! |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|