4g61t.org
http://4g61t.org/forum/

no clue what to title this one lol
http://4g61t.org/forum/viewtopic.php?f=6&t=41011
Page 1 of 1

Author:  slowdsm [ Mon Apr 17, 2017 10:07 am ]
Post subject:  no clue what to title this one lol

so im building a 2.0 for my van.. getting the eagle H beam (1g) rods with the 22mm small end.. my question is do I buy 2g pistons (which I assume I do) and next is do I need to do any machine work to the rod/pistons to make them fit?
i read in the past when using that combo u had to have either the piston or rod machined to clear the piston.... but that was with stock parts.. and other than the hole.


thx
Steve

Author:  Keane [ Mon Apr 17, 2017 3:39 pm ]
Post subject:  Re: no clue what to title this one lol

I believe in the old days the 1g small end was also to fat to fit in the 2g piston but I'm sure that's addressed now that they make a 1g rod with the 2g 22mm end on it. I think the only other thing was to verify no contact on the piston oil squirters. If there is contact Either bend them or go to the evo squirters

Author:  slowdsm [ Mon Apr 17, 2017 3:56 pm ]
Post subject:  Re: no clue what to title this one lol

so 2g pistons and watch for squirters . got it thx.

Page 1 of 1 All times are UTC-05:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/