4g61t.org http://4g61t.org/forum/ |
|
Oil pressure guage http://4g61t.org/forum/viewtopic.php?f=6&t=40800 |
Page 1 of 1 |
Author: | drcolt2000 [ Fri Sep 23, 2016 10:34 pm ] |
Post subject: | Oil pressure guage |
Im not running an oil guage yet. What can anyone share that has done the swap? |
Author: | Keane [ Sat Sep 24, 2016 9:45 am ] |
Post subject: | Re: Oil pressure guage |
I would just go aftermarket so you get an actual gauge too. Just be sure to buy the special fitting that allows you to thread the pressure sensor into you filter housing. It converts bspt to npt. |
Author: | thomcasey [ Mon Sep 26, 2016 8:34 am ] |
Post subject: | Re: Oil pressure guage |
That is the best ^^^^ I ran GlowShift electronic Oil Pressure, Coolant Temp and Boost (took them into my GVR4 and still run them without issue) Sensor fit without modifications and had plenty of clearance from the cross-member to avoid contact when the motor shifts. |
Author: | LILEVO [ Wed Sep 28, 2016 8:52 pm ] |
Post subject: | Re: Oil pressure guage |
Make sure to remotely mount the sender away from the block. 12" or so of 4an line. Vibration kills pressure senders. |
Author: | drcolt2000 [ Mon Oct 03, 2016 6:26 am ] |
Post subject: | Re: Oil pressure guage |
So the factory sender doesn't get used to send a signal to an aftermarket gauge? |
Author: | malac0da [ Mon Oct 03, 2016 11:12 pm ] |
Post subject: | Re: Oil pressure guage |
The oil pressure gauge should come with sending unit. Also I found out a few weeks ago that the port you will use is not NPT it is 1/8" BSPT so you would need an adapter or to retap it 1/8" NPT. |
Page 1 of 1 | All times are UTC-05:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |