OEM AC bracket thickness = 8mm
8mm SS spacers torqued 29/39 ft.lbs ( FSM )
| 4g61t.org http://4g61t.org/forum/ |
|
| Intermediate shaft question http://4g61t.org/forum/viewtopic.php?f=6&t=35529 |
Page 1 of 1 |
| Author: | amoney90 [ Mon Oct 31, 2011 2:07 pm ] |
| Post subject: | Intermediate shaft question |
can anyone tell me if a 2nd gen dsm shaft will work for me? I have a 92 colt with 4g63t with a fwd dsm trans and original colt turbo axles. Any help is appreciated thanks. |
|
| Author: | twokss [ Wed Nov 02, 2011 4:46 pm ] |
| Post subject: | Re: Intermediate shaft question |
Your factory turbo axles will work with the Dsm trans....if that helps |
|
| Author: | Mechacode [ Thu Nov 03, 2011 1:53 pm ] |
| Post subject: | Re: Intermediate shaft question |
I'm not sure if a 2g will work, the transmissions are different than the 1g trans. It can't be that hard to find a 1g halfshaft. |
|
| Author: | amoney90 [ Fri Nov 04, 2011 10:48 pm ] |
| Post subject: | Re: Intermediate shaft question |
one more question, how thick of spacers do I need to make up for the lack of ac bracket? |
|
| Author: | 89Mirageman [ Fri Nov 04, 2011 11:33 pm ] |
| Post subject: | Re: Intermediate shaft question |
I usually just trim the corner of the ac bracket off and use that as the spacer. |
|
| Author: | Mechacode [ Sat Nov 05, 2011 3:23 am ] |
| Post subject: | Re: Intermediate shaft question |
Use the trimmed a/c bracket or hardened washers. They absolutely have to be hardened washers too, no 5cent regular washers. There's no real set amount of spacing, add/subtract washers until the shaft is spinnable by hand with it bolted down. |
|
| Author: | Flying Eagle [ Sat Nov 05, 2011 11:06 am ] |
| Post subject: | Re: Intermediate shaft question |
If someone had the bracket lying around, they could measure the depth of the hole? |
|
| Author: | ColtiXim [ Sat Nov 05, 2011 1:59 pm ] |
| Post subject: | Re: Intermediate shaft question |
OEM AC bracket thickness = 8mm 8mm SS spacers torqued 29/39 ft.lbs ( FSM )
|
|
| Author: | Flying Eagle [ Sat Nov 05, 2011 7:17 pm ] |
| Post subject: | Re: Intermediate shaft question |
^^^ Awesome!!! |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|