| 4g61t.org http://4g61t.org/forum/ |
|
| CSM "drop in" walbro part number? http://4g61t.org/forum/viewtopic.php?f=6&t=35471 |
Page 1 of 1 |
| Author: | biglady112 [ Mon Oct 17, 2011 11:15 pm ] |
| Post subject: | CSM "drop in" walbro part number? |
I searched for a bit and did not find what I was looking for. What is the closer to drop in of the two 255 walbro fuel pumps in a CSM? The GSS 342 or GSS 342? The outlet/inlet on the same side or opposite? |
|
| Author: | 89Mirageman [ Tue Oct 18, 2011 8:30 am ] |
| Post subject: | Re: CSM "drop in" walbro part number? |
Not sure about the part # but I got the one made for a 1g fwd dsm and it dropped right in. |
|
| Author: | biglady112 [ Tue Oct 18, 2011 8:49 am ] |
| Post subject: | Re: CSM "drop in" walbro part number? |
That is the GSS 342. Just for future reference for folks looking for the answer. I have a shot at picking up a 341 from a friend. It is the same as the 1G AWD. While the inlet/outlet are different, I am going to run with it and make it work for the price. Thanks for the answer man. |
|
| Author: | 89Mirageman [ Tue Oct 18, 2011 10:38 am ] |
| Post subject: | Re: CSM "drop in" walbro part number? |
I don't blame you for trying to save a few bucks, shouldn't be too hard to mod it to fit. |
|
| Author: | joemoto [ Wed Oct 19, 2011 9:28 pm ] |
| Post subject: | Re: CSM "drop in" walbro part number? |
I need to buy a fuel pump and was considering either a Walbro 255 or a Denso 1020; the Denso 1020 because they are quiet and reliable or the Walbro because it is cheaper. How loud are they? I'm not familiar with how noisy the Walbro is though I've heard that they can whine. -Joe |
|
| Author: | biglady112 [ Wed Oct 19, 2011 9:43 pm ] |
| Post subject: | Re: CSM "drop in" walbro part number? |
It depends. Some are some are not. This one we just did is super quiet. I did one on a covertible before and it was ridiculous. |
|
| Author: | 89Mirageman [ Thu Oct 20, 2011 11:03 pm ] |
| Post subject: | Re: CSM "drop in" walbro part number? |
The 190 I put in my other black colt whined a little. |
|
| Author: | Mechacode [ Fri Oct 21, 2011 12:27 am ] |
| Post subject: | Re: CSM "drop in" walbro part number? |
I did a 255HP and reused the factory pump's rubber isolators. I bent the cage a little and added a piece of rubber for even more isolation and a snug fit. Mine is nothing more than a low hum at best, can't hear it at all while driving. |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|