| 4g61t.org http://4g61t.org/forum/ |
|
| block help http://4g61t.org/forum/viewtopic.php?f=6&t=3212 |
Page 1 of 1 |
| Author: | customthecoltgt [ Tue Mar 04, 2003 1:09 pm ] |
| Post subject: | block help |
Is the 4g61t block the same as the 4g61 block with just different pistons. if so i can go pic up two 4g61 block for penneys. |
|
| Author: | dsmracer [ Tue Mar 04, 2003 2:13 pm ] |
| Post subject: | |
The bare blocks should be the same. |
|
| Author: | rallyguytoo [ Tue Mar 04, 2003 2:26 pm ] |
| Post subject: | squirters? |
The 4g61t block might have squirters for the rods? This is the only difference between the 4g63 and 63t. Also check to make sure there is a knock sensor tapped hole on the non-t. Chris |
|
| Author: | MIRAGEDOHCTURBO [ Wed Mar 05, 2003 1:13 am ] |
| Post subject: | |
CAPS shows the the 61t block has the squirters. so it might be safe to assume the 61, 61t diffrences are the same as the 63, 63t block in the forged dept. |
|
| Author: | phntmenace [ Wed Mar 05, 2003 2:17 pm ] |
| Post subject: | Re: block help |
Quote: Is the 4g61t block the same as the 4g61 block with just different pistons. if so i can go pic up two 4g61 block for penneys.
I HAVE a good 4G61t core block/crank/and rods..... 200.00.....If I put it together it'll cost you 450.00 for a fully built stock bottom end... Geoff Mach V |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|