4g61t.org

Specializing in the 3g CSM
It is currently Sun Oct 26, 2025 9:36 pm

» »

All times are UTC-05:00



Post new topic  Reply to topic  Page 1 of 1
  [ 5 posts ] 
  Print view Previous topic | Next topic 
Author Message
customthecoltgt
 Post subject: block help
PostPosted: Tue Mar 04, 2003 1:09 pm 
Offline
Member

Joined: Mon Feb 10, 2003 1:53 pm
Posts: 159
Location: Austin, Texas
Is the 4g61t block the same as the 4g61 block with just different pistons. if so i can go pic up two 4g61 block for penneys.
Top
   
Reply with quote  
dsmracer
 Post subject:
PostPosted: Tue Mar 04, 2003 2:13 pm 
Offline
BANNED FOR FRAUD
User avatar

Joined: Thu Feb 21, 2002 7:00 pm
Posts: 1796
Location: Cardiff by the Sea, SoCal USA
The bare blocks should be the same.

_________________
Jason Veraldi
Scammer
http://www.4g61t.org/forum/viewtopic.php?f=3&t=34532
Top
   
Reply with quote  
rallyguytoo
 Post subject: squirters?
PostPosted: Tue Mar 04, 2003 2:26 pm 
Offline
Restricted Newbie

Joined: Thu Feb 13, 2003 12:43 pm
Posts: 13
Location: San Jose, CA
The 4g61t block might have squirters for the rods? This is the only difference between the 4g63 and 63t. Also check to make sure there is a knock sensor tapped hole on the non-t.

Chris
Top
   
Reply with quote  
MIRAGEDOHCTURBO
 Post subject:
PostPosted: Wed Mar 05, 2003 1:13 am 
Offline
Spends Too Much Time Under The Hood
User avatar

Joined: Tue Nov 06, 2001 7:00 pm
Posts: 295
Location: New Jersey Drive
CAPS shows the the 61t block has the squirters. so it might be safe to assume the 61, 61t diffrences are the same as the 63, 63t block in the forged dept.
Top
   
Reply with quote  
phntmenace
 Post subject: Re: block help
PostPosted: Wed Mar 05, 2003 2:17 pm 
Offline
Spends Too Much Time Under The Hood

Joined: Fri Nov 16, 2001 7:00 pm
Posts: 382
Location: Beltsville, MD
Quote:
Is the 4g61t block the same as the 4g61 block with just different pistons. if so i can go pic up two 4g61 block for penneys.
I HAVE a good 4G61t core block/crank/and rods..... 200.00.....

If I put it together it'll cost you 450.00 for a fully built stock bottom end...



Geoff
Mach V
Top
   
Reply with quote  
Display posts from previous:  Sort by  
Post new topic  Reply to topic  Page 1 of 1
  [ 5 posts ] 

» »

All times are UTC-05:00

Who is online

Users browsing this forum: No registered users and 12 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited