| 4g61t.org http://4g61t.org/forum/ |
|
| Need resources specs ect ect http://4g61t.org/forum/viewtopic.php?f=6&t=15843 |
Page 1 of 1 |
| Author: | chdesign [ Wed Nov 16, 2005 10:21 am ] |
| Post subject: | Need resources specs ect ect |
Ok guys flood me with specs on the 4G61T CC size, cumbustion chamber size, rod lenth, pin diameter, Dish CC, bore, stroke anything you guys can think of. I know a few of these and the specs are scattered throughout the board I would like to get a consolidated list for those of us who wish to order custom forged pistons.....unless any of you know of a company that has specs for a 4G61T for forged goodies....I know the rods are 1G rods and can be found and replaced easily. Come on guys lets see those specs!!!!! |
|
| Author: | Flying Eagle [ Wed Nov 16, 2005 10:33 am ] |
| Post subject: | |
PM your email address and I can send most of the stuff you want; barring that, check this info out: Bore = 82.3mm (3.24") Stroke = 75mm (2.95") Piston displacement = 1,595 cc (97ci) Compression ratio NA = 9.2:1 T/C = 8.0:1 More to come if I find it. Other members have been throught the more serious points of pistons in diameters and such though. |
|
| Author: | Berserko [ Wed Nov 16, 2005 11:19 am ] |
| Post subject: | |
Rod Length 150mm Head CC= 43cc Head Gasket Thickness = 1.1mm Deck clearence 0 Wrist Pin Diameter = 21mm |
|
| Author: | Berserko [ Wed Nov 16, 2005 11:26 am ] |
| Post subject: | |
Using the numbers I plugged into a static compression calculator I calculated a 8cc piston dish nets a 8.03:1 compression ratio. For reference a 4g63 has a 17cc dish in them |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|