4g61t.org

Specializing in the 3g CSM
It is currently Mon Oct 27, 2025 9:53 am

» »

All times are UTC-05:00



Post new topic  Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
cheeks
PostPosted: Mon Apr 04, 2005 11:48 am 
Offline
Restricted Newbie

Joined: Mon Apr 04, 2005 11:28 am
Posts: 8
Location: Cairns, Australia
Hi everybody,
I'm from Australia and have had so many dramas finding wiring schematics so I can connect the standard tacho to an autronic SMC. I am currently running an aftermarket item on the dash but would prefer to run the OEM one to keep my sleeper look. Any suggestions or links that could help me?
Top
   
Reply with quote  
monsterbishi
 Post subject:
PostPosted: Mon Apr 04, 2005 5:08 pm 
Offline
Spends Too Much Time Under The Hood

Joined: Mon Oct 27, 2003 1:00 am
Posts: 272
Location: Christchurch, New Zealand
There's only two wires that need to be connected on the dash end, TM and TM ground, they have small screws going into them that you can undo and put a ring style crimp piece onto.

TM ground just needs a good earth, TM goes to the tach signal wire that goes to/from the ecu.
Top
   
Reply with quote  
Display posts from previous:  Sort by  
Post new topic  Reply to topic  Page 1 of 1
  [ 2 posts ] 

» »

All times are UTC-05:00

Who is online

Users browsing this forum: No registered users and 5 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited