| 4g61t.org http://4g61t.org/forum/ |
|
| Help! problem with passenger side axle http://4g61t.org/forum/viewtopic.php?f=57&t=40156 |
Page 1 of 1 |
| Author: | Autocrossn [ Thu May 14, 2015 12:19 am ] |
| Post subject: | Help! problem with passenger side axle |
1992 colt just finishing up the awd auto swap Put the passenger side axle in and couldnt bolt the knuckle to the strutt The bottom hole lines up but the top is about a quarter inch off (axle is completely compressed so you cant push/angle the knuckle closer to the car) using expo knuckles/dsm hubs Elantra controll arms Dsm strutts with colt top hats Its like the controll arm isnt long enough The strutt bolt holes are in the wrong spots other wise the only way to fix it would be to get camber plates and run negative camber... |
|
| Author: | j2dapo [ Thu May 14, 2015 11:35 am ] |
| Post subject: | Re: Help! problem with passenger side axle |
What axles? |
|
| Author: | Autocrossn [ Thu May 14, 2015 12:04 pm ] |
| Post subject: | Re: Help! problem with passenger side axle |
sorry thought I said them There dsm axles 1g auto awd With the expo knuckles and elantra control arms i'm supposed to be able to use them |
|
| Author: | fastvtgsx [ Thu May 14, 2015 3:19 pm ] |
| Post subject: | Re: Help! problem with passenger side axle |
Sounds like you don't have the axles you think you have. But if the axle is all the way seated in the trans and you're positive it is a DSM axle, I'd suggest trying a turbo mirage axle. |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|