http://www.mandhtires.com/M-H-Racemaste ... P235-60-15
| 4g61t.org http://4g61t.org/forum/ |
|
| 26 inch tall tire http://4g61t.org/forum/viewtopic.php?f=57&t=39248 |
Page 1 of 1 |
| Author: | SSlow [ Tue Nov 11, 2014 7:47 pm ] |
| Post subject: | 26 inch tall tire |
Anyone tried this seen 24.5 but what about a 26 |
|
| Author: | Natedog [ Tue Nov 11, 2014 8:26 pm ] |
| Post subject: | Re: 26 inch tall tire |
Youll have to jack the car up.... |
|
| Author: | Bet [ Tue Nov 11, 2014 10:43 pm ] |
| Post subject: | Re: 26 inch tall tire |
You will need a small "lift" if that makes sense... Check out Ostars mirage, they are on 26's I believe. |
|
| Author: | Spoolin [ Tue Jan 19, 2016 7:11 am ] |
| Post subject: | Re: 26 inch tall tire |
viewtopic.php?f=44&t=35498&start=15 I know they fit on front. |
|
| Author: | LILEVO [ Sat Jan 23, 2016 5:03 pm ] |
| Post subject: | Re: 26 inch tall tire |
http://www.mandhtires.com/M-H-Racemaste ... P235-60-15 |
|
| Author: | lancerman [ Sat Jan 23, 2016 5:46 pm ] |
| Post subject: | Re: 26 inch tall tire |
seems like the definition of tires that dont fit. |
|
| Author: | wrx110487 [ Sun Jan 24, 2016 12:19 am ] |
| Post subject: | Re: 26 inch tall tire |
They're actually rated at 25.4" tall but most people classify them as a 26" tire. 235/60/15 Bias-plys same as Lilevo. The wheels are 15x7 +40. 
|
|
| Author: | 1japdsm [ Wed Jul 20, 2016 1:42 pm ] |
| Post subject: | Re: 26 inch tall tire |
Quote: They're actually rated at 25.4" tall but most people classify them as a 26" tire. 235/60/15 Bias-plys same as Lilevo. The wheels are 15x7 +40.
That looks bad ass!
|
|
| Author: | wrx110487 [ Wed Jul 20, 2016 8:24 pm ] |
| Post subject: | Re: 26 inch tall tire |
They looked nasty on the car but were just too tall for what I was trying to do. I'd have to jack the car pretty damn high to get them to comfortably fit and I still wouldn't be able to turn fully. They'd be fine for just the drag strip, but if you're not trying to fit into DOT approved tire class or something like that, then you might as well just go to a full slick. I wish someone would just make a 24.5" Bias Ply already. I'm pretty sure I'm going to give the Mickey Thompson ET Street R's in 225/50/15 a shot. Everyone who runs them, have had nothing but good things to say and at around 24" tall they might be perfect. |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|