| 4g61t.org http://4g61t.org/forum/ |
|
| Thickness Measure On Eng. Support http://4g61t.org/forum/viewtopic.php?f=57&t=22893 |
Page 1 of 1 |
| Author: | Bill Spruill [ Wed Oct 24, 2007 6:05 pm ] |
| Post subject: | Thickness Measure On Eng. Support |
Thanks to all of the guys who have been nice enough to post their methods on AWD conversions, I have a good array of suggested lengths and shapes (eg., bar, box, angle, or channel) for making eng. support and rear suspension pieces. However, nobody mentioned the "thickness" for these shapes. I bought a bunch of stuff at 1/4" thickness. That seems hemongus. What are suggested sizes? I am wondering between 1/8 or 1/16th. Any help? |
|
| Author: | gsx [ Thu Oct 25, 2007 1:10 pm ] |
| Post subject: | |
Everything in my car was made from 1/8 plate. |
|
| Author: | Bill Spruill [ Thu Oct 25, 2007 2:15 pm ] |
| Post subject: | |
OK. That was easy. I will do the same. Thanks. |
|
| Author: | MR HYDE [ Thu Oct 25, 2007 3:06 pm ] |
| Post subject: | Re: Thickness Measure On Eng. Support |
Quote: Thanks to all of the guys who have been nice enough to post their methods on AWD conversions, I have a good array of suggested lengths and shapes (eg., bar, box, angle, or channel) for making eng. support and rear suspension pieces. However, nobody mentioned the "thickness" for these shapes. I bought a bunch of stuff at 1/4" thickness. That seems hemongus. What are suggested sizes? I am wondering between 1/8 or 1/16th. Any help?
.020 wall 2x2 box and 1/8 in plates.....
|
|
| Author: | 89coltgt [ Fri Oct 26, 2007 2:22 am ] |
| Post subject: | Re: Thickness Measure On Eng. Support |
Quote: Quote: Thanks to all of the guys who have been nice enough to post their methods on AWD conversions, I have a good array of suggested lengths and shapes (eg., bar, box, angle, or channel) for making eng. support and rear suspension pieces. However, nobody mentioned the "thickness" for these shapes. I bought a bunch of stuff at 1/4" thickness. That seems hemongus. What are suggested sizes? I am wondering between 1/8 or 1/16th. Any help?
1/8" wall 2x2 box and 1/8 in plates..... |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|