| 4g61t.org http://4g61t.org/forum/ |
|
| strapped the car on the Dyno http://4g61t.org/forum/viewtopic.php?f=3&t=15300 |
Page 1 of 1 |
| Author: | MattGSR [ Sat Sep 24, 2005 3:19 pm ] |
| Post subject: | strapped the car on the Dyno |
Went early this morning to a Dyno Day sponsored by a local shop (Modacar) here in Norcal to get some baseline runs. Meet/dyno was set-up by guys from honda-tech and i managed to slip in for a timeslot. Three runs on a dynojet with air/fuel readings. here's the results First run: 135.66 HP / 138.65 TQ 2nd run : 133.97 HP/ 136.47 TQ 3rd run : 135.29 HP/ 138.99 TQ conditions : 74 degrees 18%Humidity peakHP around 6k rpm and peak TQ around 4200 rpm There were a lot of nice Honda's and 2 lotus elise and 2 Evos. Wasn't expecting much from the set-up, basically stock 2.0, non-intercooled, stock boost 14b and only cat-back exhaust and K &N filter. Downpipe is stock and very restricted, lol. I have a downpipe and FMIC sitting in the garage im putting on in two weeks. |
|
| Author: | Aaron_37 [ Sat Sep 24, 2005 7:32 pm ] |
| Post subject: | |
I hope you mean stock 1.6 Non intercooled, because I've NEVER seen a DSM without an intercooler. |
|
| Author: | Doomsbright [ Sat Sep 24, 2005 8:04 pm ] |
| Post subject: | |
You dont have a 4G63T do you? |
|
| Author: | MattGSR [ Sun Sep 25, 2005 3:00 am ] |
| Post subject: | |
yes it does, i should put info bout my car in my sig, lol |
|
| Author: | Doomsbright [ Sun Sep 25, 2005 9:50 am ] |
| Post subject: | |
Make sure you post your next dyno run after the downpipe/FMIC... |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|