4g61t.org http://4g61t.org/forum/ |
|
Development of New Products http://4g61t.org/forum/viewtopic.php?f=3&t=1512 |
Page 2 of 2 |
Author: | xlr8 [ Wed Dec 31, 1969 7:00 pm ] |
Post subject: | |
ah I see, I want some poly endlinks for my X2 so I thought I'd just slip that one in there. Assumption is the basis of all fruit and banana. Poly/Nylon would probably not make much of a difference compared to stock rubber items on those parts. Nylon engine mounts would be nasty however. Same for the lower control arms - you might possibly run the risk of cracking a weld eventually. |
Author: | Berserko [ Wed Dec 31, 1969 7:00 pm ] |
Post subject: | |
One thing I would like to see is the rear lower strut bushing for the Mriage. I think DSS used to carry them but they don't seem to anymore. I had to hack up my old struts when I put in my GR2's. It was a pain and my bushings are a bit worn to start with so if I could get some replacements id be all over that. |
Author: | billnutz [ Wed Dec 31, 1969 7:00 pm ] |
Post subject: | |
We now have 3 turbo C/Ms at the shop. Two 4G61s and a 4G63. Here are the items we'd buy tomorrow, if available, in the order we'd like to see them (we could also sell these, as we've already made believers of a few locals that are considering 4G63 into base model swaps): 1) Thermal R&D 3" Cat-back. We'd buy three ASAP. 2) Short-throw shifter. We'd buy three ASAP 3) Front and rear strut tower braces (weren't these supposedly in development somewhere?) 4) 22mm rear sway bar 5) A good 2-pod A-pillar pod The hood might sell to a few, but a CF hood is just too nice for most of our cars The coil-over setup is also too much when you can do DSS's setup and Koni Yellows for less. Let us know! Bill T. |
Page 2 of 2 | All times are UTC-05:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |