4g61t.org http://4g61t.org/forum/ |
|
Elvie has left the building http://4g61t.org/forum/viewtopic.php?f=3&t=8209 |
Page 2 of 3 |
Author: | mysteryman [ Sun May 23, 2004 1:51 am ] |
Post subject: | |
Elvis has left the building |
Author: | mysteryman [ Mon May 31, 2004 7:54 am ] |
Post subject: | |
Elvis has left the building |
Author: | mysteryman [ Tue Jun 01, 2004 1:06 am ] |
Post subject: | |
Elvis has left the building |
Author: | mysteryman [ Tue Jun 01, 2004 1:13 am ] |
Post subject: | |
Elvis has left the building |
Author: | mysteryman [ Wed Jun 02, 2004 7:28 am ] |
Post subject: | |
Elvis has left the building |
Author: | mysteryman [ Wed Jun 02, 2004 7:42 am ] |
Post subject: | |
Elvis has left the building |
Author: | snowdevl [ Thu Jun 03, 2004 7:23 am ] |
Post subject: | |
Quote: Stuffed a Blue WRX yesterday
cool, seems as though everyones wasting these WRXs....ohhhh....im missing out....
|
Author: | mysteryman [ Fri Jun 04, 2004 9:26 am ] |
Post subject: | |
Elvis has left the building |
Author: | mysteryman [ Sun Jun 06, 2004 3:20 pm ] |
Post subject: | |
Ok throw out bearing was on its way out figured why not just install a new one and install a new axle while I was at it since my CV on one side was clicking. Well this was just a mess, nobody had the drivers side axle, but hey I go the throw out bearing, cool. Did the swap, finally got it all buttoned up and what do you think??? Yeah the new bearing is defective, rattles like a rattle snake all pissed off! So going tomorrow to get a new throw out bearing from the dealer, and then getting my axle rebuilt. Then install everything so I can get my new tires and the alignment. UUUUUUUUGGGGGGHHHHH! Ok done now... |
Author: | mysteryman [ Wed Jun 16, 2004 8:07 am ] |
Post subject: | |
Elvis has left the building |
Author: | mysteryman [ Sun Jun 27, 2004 12:19 am ] |
Post subject: | |
Elvis has left the building |
Author: | phntmenace [ Sun Jun 27, 2004 6:40 am ] |
Post subject: | |
Quote: I just hate the fact the exhaust will be slung so low because I am already scraping every speed bump as is, cannot imagine the exhaust hanging even lower due to the AWD drive shaft taking its place.
The exhaust doesn't have to hang low.... reposition your exhaust so it hangs NEXT to the driveshaft
|
Author: | mysteryman [ Tue Jun 29, 2004 3:35 pm ] |
Post subject: | |
Elvis has left the building |
Author: | mysteryman [ Thu Jul 01, 2004 7:41 am ] |
Post subject: | |
Elvis has left the building |
Author: | mysteryman [ Wed Jul 07, 2004 10:48 am ] |
Post subject: | |
Elvis has left the building |
Page 2 of 3 | All times are UTC-05:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |