4g61t.org

Specializing in the 3g CSM
It is currently Tue Mar 19, 2024 12:38 am

All times are UTC-05:00




Post new topic  Reply to topic  [ 35 posts ]  Go to page Previous 1 2 3
Author Message
 Post subject: Re: BCS installation
PostPosted: Sat Aug 27, 2016 5:07 pm 
Offline
Member

Joined: Tue May 12, 2009 3:44 am
Posts: 77
Location: California
good news. swapped the o2 sensor and my idle is perfect. thanks for all your help flying eagle


Top
   
 Post subject: Re: BCS installation
PostPosted: Sun Aug 28, 2016 9:56 am 
Offline
The Silent Administrator
User avatar

Joined: Wed Dec 24, 2003 3:32 pm
Posts: 9524
Location: Ottawa, ON, Canada
Wasn't expecting a wonky o2 sensor, but my car ran badly with an 02 that had no miles on it (all idle), and that was legged at 0.2v. No upswing!

No surge now? Repeated cycling high to low with nearly stalling out?


Top
   
 Post subject: Re: BCS installation
PostPosted: Mon Aug 29, 2016 9:59 am 
Offline
Member

Joined: Tue May 12, 2009 3:44 am
Posts: 77
Location: California
No surge at idle. Still getting high idle when I coast I'm thinking isc is faulty I have a 1g tb I can install but I'm waiting for my 6 bolt to arrive


Top
   
 Post subject: Re: BCS installation
PostPosted: Mon Aug 29, 2016 10:05 pm 
Offline
The Silent Administrator
User avatar

Joined: Wed Dec 24, 2003 3:32 pm
Posts: 9524
Location: Ottawa, ON, Canada
Confirm you have a ground plate bracket that goes from the top Phillips screw on the TB to the TB elbow bolt/stud/nut. This is the ground path for the idle stop switch. That and a good ground wire from the one ten mm bolt head on the bolt closest the TB that holds the throttle cable to the intake manifold. One of the two bolts, doesn't matter which. My car loves to sit just above idle when I clutch/pop to neutral and coast to a stop, a different routine than clutch in /neutral just as you stop and just before the engage starts to bog. Doesn't like the first few idle drops at stops, before warming up. Any extra load on the motor exacerbates the situation, like fan(s), lights, AC, Etc.


Top
   
 Post subject: Re: BCS installation
PostPosted: Mon Sep 05, 2016 8:29 pm 
Offline
Member

Joined: Tue May 12, 2009 3:44 am
Posts: 77
Location: California
ill look into that thanks. been doing a battery relocation and starting my smic installation. gonna post in the forum for pictures of 1g smic setups so i can get an idea of how to mount and run the piping.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 35 posts ]  Go to page Previous 1 2 3

All times are UTC-05:00


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited