4g61t.org

Specializing in the 3g CSM
It is currently Sat Jun 23, 2018 8:31 am

All times are UTC-05:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
 Post subject: 4G63T SWAP
PostPosted: Wed Dec 31, 1969 7:00 pm 
Here is a quick guideline for performing the 4G63T Engine swap into a '89-'92 Chassis.


'89 Mirage/Colt Turbo 1.6L
You will need the following parts:
-engine
-flywheel/clutch

If you get a engine from a 1990 car, then it will bolt right in. If you get it from the later years, you will have to mix and match some of the sensors and accessories to get it to work.

'90-92 Mirage/Colt/Summit Non-Turbo 1.6L
You will need the following parts:
-engine
-flywheel/clutch
-ecu
-wiring harness (or add your own wires)

What else goes here? I'm not sure as this swap isn't mentioned often.


'89-92 Mirage/Colt/Summit Non-Turbo 1.5L

You will need the following parts:
-complete engine (injectors, turbo, manifolds, tb...)
-flywheel/clutch (from the same year engine that you are going to use)
-ecu
-DSM wiring harness
-DSM tranny(or mirage turbo tranny)
-Mirage Turbo timing belt mount
-Mirage Turbo rear metal mount
-Complete Mirage Turbo transmission mount
-MPI relay
-DSM starter
-Injector resistor pack from DSM
-upgraded fuel pump



If I'm missing anything from here, please post it.

*EDIT* Flying Eagle - Lil Evo Swap Site and 4wd conversion information - the original 400 Hp 4wd swap


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC-05:00


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited