Before I begin: this post is not meant to bash or belittle superpro in any, way, shape, form, they offer decent products for our cars, and with that said.
I recently had to get some urethane busings for my Elantra lower control arms, so I checked the prices on the superpro SPF1870K shipped to me and the best I could find was almost $70 okay thats $56 for the bushings and about $20 in shipping plus I'm unsure of how long it will take for them to ship out, and I need them now, so I decide I can make...
My own solution:
I did some researching, and I eventually found the closest sized, easily available, urethane bushing.
Prothane 19-607 Red [In black: 19-607 BL] I ordered one set in red for $12, and a black set for $20, so for about $32 shipped to my house, these do not fit right off the bat but they are vary close. heres what I ended up doing.
upload photo
I took this measurement off my elantra LCA 48MM.
![Image](https://s31.postimg.cc/uxpg7id7v/20170503_164733.jpg)
then went over to the urethane bushings, and I cut off 7.5mm [I used a hack saw to start it, but a utility knife made it smother and quicker, so I only started it with the hack saw then went around the bushing with the knife
![:o](./images/smilies/icon_eek.gif)
:caution: wear thick gloves].
![Image](https://s31.postimg.cc/vzzmq8ynv/20170503_164848.jpg)
![Image](https://s31.postimg.cc/6h7ad99yz/20170503_164903.jpg)
2 Pictures above: bushing on left is stock bushing, on the right is the one I removed 7.5mm from.
imagehosting
screenshot windows
Pictured above: I measured the inside diameter it's about 34MM to 35MM so I aimed for the tighter side of spec at 35 if it's too tight you can always remove more material.
image host![Image](https://s31.postimg.cc/4dwv5g4zf/20170503_165740.jpg)
2 Pictures above: is how I removed the material, this is my "Ghetto rigged lathe":lol: I used a cordless drill a 3/8 14mm deep socket on an impact adapter [for the drill] and a 19mm combination wrench [to help stabilize the other side] if you have access to a real lathe use it, but if not and you want this done on the cheep you can do it on a bench grinder, it obviously will take a little longer but you get what you don't pay for in this case
![:lol:](./images/smilies/icon_lol.gif)
.
![Image](https://s31.postimg.cc/veanty0yz/20170503_165852.jpg)
Pictured above: I used an angle grinder, and a steady hand, and cut off 17MM from the inner metal sleeve these are 76MM out of the box but need to be about 59MM.
![Image](https://s31.postimg.cc/55zj4mm17/20170503_165954.jpg)
Pictured above:The finished product vs the stock rubber [in black: I'm still working on the red rocket ones
![:)](./images/smilies/icon_smile.gif)
.]