4g61t.org

Hey guys, I just sold a brake master cylinder off of a 95 3000GT VR-4 and I noticed that the lines and bolt spread looked the same as the one on my Colt....so I went to see how it would fit......The thing friggin bolted right up, lines, and resevoir. you go from a 7/8" brake master to a 1-1/16" with no modification!!!!!!!
and I have a bunch of these here in stock $25 each plus a few dollars for shipping
Just as a comparison, I just spent $200 on a 1-1/16" brake master from a 300zx for a Nissan 240sx drift car I have been building for a customer.

_________________
If it don't make power it's not worth the hour!!!!!

Miragetec Yes I have been running one of these for a year this is a known upgrade but the issue is they suck BAD on a mirage because ther booster is no where near as powerful as it should be for that it has like a 3.7:1 boost ratio where the 3000GT is 7:1 how much do you have the boosters for?

so are the non vr-4 master cyl's diffrent?

ABS are 1 1/16 and Non ABS are 1 Inch...

I have a bunch of boosters also, I need to pull one off of a colt to see if the 3000 booster will bolt up.....or maybe you already know
I would sell you guys the booster with the master for $75 plus some shipping.
I bet your face would hit the windshield after you put this on with some stainless lines!!! I can't wait

_________________
If it don't make power it's not worth the hour!!!!!

I'm sure my stock 1.5l solid rotors would just LOVE having that much force on them

Yes, the booster uses the same bolt pattern and the same aluminum spacer between the booster and the firewall. I forget what the diameter of the 3kgt booster is though? I remember one car used a really large diam booster that wouldnt quite fit into a colt? It was like 13" or something?

Chris

Some later year Galants w/ 180 or so HP seem to have the same booster as the Colt GTi (which is, of course, a CSM). Dunno for the 3KGT.

_________________
Got rabies?

Ok here we go, I measured a stock Colt booster and a 3000GT VR-4 booster WITH ABS

Colt booster is 8-3/4" in diameter and 3-3/8" thick from the surface that the master bolts on to the rear surface where the alum. spacer sits

3000GT booster is 9-1/4" in diameter and 4" thick measured from the same points as the Colt booster
So IT WILL FIT!!
I am going to put that set up on the AWD car this weekend

_________________
If it don't make power it's not worth the hour!!!!!

i would be intrested in buying this setup from you for that quote of $75.. let me know what goes down

Sure, let me get that thing all bolted up just to make sure, like I posted before I have a bunch of these things in stock so I will save one for you.
Thanks

_________________
If it don't make power it's not worth the hour!!!!!

cool, i was going to suggest the same thing... as long as it works for you then i'd definately be down for that combo..

I'm interested.

Miragetec so would it be $50 for the booster? if I only needed that? I have the 1 1/16 MC already without the booster its a might bit useless...

Yep, $50 for the booster

_________________
If it don't make power it's not worth the hour!!!!!