| 4g61t.org http://4g61t.org/forum/ |
|
| Transforming 4G15 to 4G61/4G67 http://4g61t.org/forum/viewtopic.php?f=17&t=8803 |
Page 1 of 1 |
| Author: | C62_drive [ Thu May 06, 2004 2:06 am ] |
| Post subject: | Transforming 4G15 to 4G61/4G67 |
Well folks, i decided to swap my '91 1,5 EFI 12valve to 4G61 or 4G67, i was searching the history, but could not find any particular information, what parts gonna fit from 4G15 and what parts should i buy necessarily, I would appreciate any information you tell! 
|
|
| Author: | The Ethereal [ Thu May 06, 2004 4:10 am ] |
| Post subject: | |
Well it should be all in the archives. Just look into them. Honestly! |
|
| Author: | mysteryman [ Thu May 06, 2004 7:13 am ] |
| Post subject: | |
Your transmission will work with the 4G61 and 4G67. You will need a different flywheel and clutch then what is on your 4G15. Most likely the 4G61 and 4G67 flywheels will work, so long as they are not from a turbo car or AWD car. As for parts off your 4G15 motor, nothing that I know of wil work. You will need parts of your old wiring harness to graph into your new 4G6X wiring harness that you will have to source out along with a 4G6X ECU. I assume at this point you are not going turbo, so you will be using naturally Aspirated ECU and wiring harness. |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|