4g61t.org

Specializing in the 3g CSM
It is currently Tue Mar 19, 2024 5:53 am

All times are UTC-05:00




Post new topic  Reply to topic  [ 61 posts ]  Go to page Previous 1 2 3 4 5
Author Message
 Post subject: Re: f5m21 trans exploded
PostPosted: Sun Feb 19, 2017 5:54 pm 
Offline
Spends Too Much Time Under The Hood
User avatar

Joined: Tue Aug 23, 2011 4:20 am
Posts: 316
Location: Turlock, California
I had to drill holes for the hydraulic clutch master on my "87 colt vistas firewall, it's not a hard job [if the engine is out of the car, or the dash is removed.] just measure a few times and drill for it once.

Cool tip: Use a Christmas tree looking, stepped drill bit for the master cylinder center hole, I bought the 2 pack of stepped bits from harbor freight [Item #69088]
http://www.harborfreight.com/titanium-n ... 69088.html

The bigger one of the two bits worked flawlessly I just needed to get the outside diameter of the master cylinder then I marked the step on the bit and I knew how far I could go before making a mess of things :lol:.

_________________
Abe


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 61 posts ]  Go to page Previous 1 2 3 4 5

All times are UTC-05:00


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited