| 4g61t.org http://4g61t.org/forum/ |
|
| Random wire under Distributor http://4g61t.org/forum/viewtopic.php?f=17&t=32826 |
Page 1 of 1 |
| Author: | Nemesis [ Tue Jun 08, 2010 5:18 pm ] |
| Post subject: | Random wire under Distributor |
Okay, there is one wire with a connector flopping around below the distributor (12v motor). It is black with a white stripe and a connector that appears to go just to a blade... can't figure out where it goes, and I wonder if that is causing my problems (mentioned in another thread). Anyone know? |
|
| Author: | Flying Eagle [ Tue Jun 08, 2010 11:17 pm ] |
| Post subject: | Re: Random wire under Distributor |
Electrical manual - Page 60 of 328 should get you most of the views of the harness's you want. Not sure if you have an 8V or 12V distributor setup. http://www.lilevo.com/mirage/89%20Colt% ... 0TURBO.pdf |
|
| Author: | Nemesis [ Thu Jun 10, 2010 5:34 pm ] |
| Post subject: | Re: Random wire under Distributor |
Its a 12V. The harness diagram kinda helped, but not really, because its pre-12v and there is no wiring color diagram... and the Haynes manual doesn't really help either. |
|
| Author: | 89Mirageman [ Thu Jun 10, 2010 7:42 pm ] |
| Post subject: | Re: Random wire under Distributor |
I think that should go to a sensor on the t-stat housing. |
|
| Author: | Nemesis [ Fri Jun 11, 2010 10:07 am ] |
| Post subject: | Re: Random wire under Distributor |
Really? I'll check that later today, but the only sensor there (that I remember) is the temp sensor, and I have that plugged in with what I believe to be the proper connector. |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|