Quote:
the rod bearing could be to tight
but the rings could be to tight in the walls also
how did the pistons go in the bore easy, lots of beating?
did you have to file the rings to the cylinder cause when i bought mine they were oversized and as in most new ring sets and must be filed
The rings went on easy and went into the cylinder with no problems or beating!! I had one of the sleeves that you put over the piston and it tightens the rings and then you just slide it into the cylinder! It didn't feel tight to get them in at all......
I'm hoping it could be a wire disconnected somewhere from the starter that won't allow it to power up. It was getting late the last day I was working on the car and it was dark and freezing so I left it! I'm dreading going back to work on it cos I don't wanna have to strip it all down again!