4g61t.org

Project is an '87 Colt premier Turbo sedan.

Engine's in. I used a fidanza 6 bolt n/a flywheel, dsm clutch, stock transmission and axles.

what from the stock colt harness do i need to cross with the 1g dsm harness?

I hate wiring...

Can the 1g ecu, harness, and engine stand separately from the rest of the car, or do i need to cross some stuff?

use the ignition wire that is in the g32b mpi relay and connect it to the 4g63t harness also the fuel pump wire on the relay and connnect it to the 4g63t harnes,, the rest of the wires that you need are in the the connector b-03 behind the heater core,,,,,,,,






hope this help you,, send me your e-mail and i will mail them to you

_________________
1987 C10 mitsu mirage 2.0 turbo (mean sleeper) in rerstoration process

you will need to cross ref ign, starter signal , constant 12 v and back up power


theres a blue connector on the 4g63t harness, there is everything that you need to connnect at the mirage

_________________
1987 C10 mitsu mirage 2.0 turbo (mean sleeper) in rerstoration process