You keep mentioning parts from a DSM. They dont exists over here and never were available!!!
Other suggestions for lowering?
| 4g61t.org http://4g61t.org/forum/ |
|
| DSMs (Eclipse/Talon?) - They dont exist here http://4g61t.org/forum/viewtopic.php?f=16&t=1428 |
Page 1 of 1 |
| Author: | coltturbouk [ Wed Dec 31, 1969 7:00 pm ] |
| Post subject: | DSMs (Eclipse/Talon?) - They dont exist here |
You keep mentioning parts from a DSM. They dont exists over here and never were available!!! Other suggestions for lowering? |
|
| Author: | evo_jr [ Wed Dec 31, 1969 7:00 pm ] |
| Post subject: | |
AGSS (angle grinder suspension system) it works but it ain't pretty 
|
|
| Author: | coltturbouk [ Wed Dec 31, 1969 7:00 pm ] |
| Post subject: | |
I've cut the srpings front and rear but the front ones aren't held by the strut until the car is on the ground (off the jack). I dont think it's safe! |
|
| Author: | BlueBullet [ Wed Dec 31, 1969 7:00 pm ] |
| Post subject: | |
yea because unfortunatley when it comes to japanese performance cars...we always get shafted.....so while everyone else gets the real deal crazy ass lancer....we get a talon/eclipse...with a kinda similar motor, but the motors been swapped 180 degrees...where as the lancer block is sitting on the right side of the car....over here..the DSM block is on the driverside..... |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|